[asterisk-users] [asterik-users] Installing PRI card

[Eric Wieling]

Try "module load chan_zap.so"  in the CLI. You should see whatever errors are generated.

-----Original Message-----
From: asterisk-users-bounces at lists.digium.com [mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of NaJIm
Sent: Thursday, September 29, 2011 5:52 PM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: [asterisk-users] [asterik-users] Installing PRI card

Hi,

We have got a new PRI card at one of our Office locations and now I need to install the the device on a remote server.  Is there any way to know if the device is loaded already.

When I give " cat /proc/zaptel/* " it returns the following.


			# cat /proc/zaptel/*

			Span 1: WCT1/0 "Wildcard TE122 Card 0" (MASTER) B8ZS/ESF RED

			        IRQ misses: 2


			           1 WCT1/0/1 Clear (In use) RED

			           2 WCT1/0/2 Clear (In use) RED

			           3 WCT1/0/3 Clear (In use) RED

			           4 WCT1/0/4 Clear (In use) RED

			           5 WCT1/0/5 Clear (In use) RED

			           6 WCT1/0/6 Clear (In use) RED

			           7 WCT1/0/7 Clear (In use) RED

			           8 WCT1/0/8 Clear (In use) RED

			           9 WCT1/0/9 Clear (In use) RED

			          10 WCT1/0/10 Clear (In use) RED

			          11 WCT1/0/11 Clear (In use) RED

			          12 WCT1/0/12 Clear (In use) RED

			          13 WCT1/0/13 Clear (In use) RED

			          14 WCT1/0/14 Clear (In use) RED

			          15 WCT1/0/15 Clear (In use) RED

			          16 WCT1/0/16 Clear RED

			          17 WCT1/0/17 Clear (In use) RED

			          18 WCT1/0/18 Clear (In use) RED

			          19 WCT1/0/19 Clear (In use) RED

			          20 WCT1/0/20 Clear (In use) RED

			          21 WCT1/0/21 Clear (In use) RED

			          22 WCT1/0/22 Clear (In use) RED

			          23 WCT1/0/23 Clear (In use) RED

			          24 WCT1/0/24 HDLCFCS (In use) RED


But when I connect to the console, I am unable to give any ZAP related commands. Does this mean that my device is loaded and I just need to load the module. Or do I need to compile asterisk again?? Any help would be highly appreciated. 

My asterisk version is  Asterisk 1.4.19.2 and I am on a Fedora release 9 server.

Thanks,
Najim