[asterisk-users] Trouble with PRI config

[Steve Totaro]

On Thu, Jun 19, 2008 at 6:41 PM, Steve Totaro
<stotaro at totarotechnologies.com> wrote:
> On Thu, Jun 19, 2008 at 4:11 PM, Steve Edwards
> <asterisk.org at sedwards.com> wrote:
>> On Thu, 19 Jun 2008, Eve-Ellen Cole wrote:
>>
>>> Right again, getting a little closer (babysteps) ... no alarms on either
>>> system, but when I check the pri status in the CLI, I get PRI span 2/0:
>>> Provisioned, Down, Active.  I've searched for clues, but am not coming up
>>> with the next step.
>>
>> It's not my area of expertise, but I have "issues" with T1 numbering
>> between vendors -- what they said was 1, 2, 3, 4 turned out to be 4,
>> 3, 2, 1.
>>
>> You might try swapping the T1s and see what happens.
>>
>> Thanks in advance,
>> ------------------------------------------------------------------------
>> Steve Edwards      sedwards at sedwards.com      Voice: +1-760-468-3867 PST
>> Newline                                             Fax: +1-760-731-3000
>>
>
> I have actually done this with a Definity G3 but the cards were not
> PRI, I had to use E&M_W.
>
> This doesn't make sense to me though.
> Primary d-channel set to 01C14
>
> I memory servers me correctly (and it has been a couple years) the 01
> means cabinet 1, C is the slot, and 14 is the port number.  I would
> expect it to say 01C24 for the D chan.  I could be completely wrong
> but it is something to try and would explain why your PRI chans are
> not coming up.
>
> Thanks,
> Steve Totaro
>

BTW, if that does turn out to be the issue, feel free to figure out
how many hours you would have spent to figure it out and you can
PayPal me your hourly rate multiplied by how much time I saved you.

Definity support ain't cheap! ;-)

Thanks,
Steve T