[asterisk-users] Polycom IP4000 - Device does not match ACL

[CunningPike]

Try 'ip4000_1' instead of '207' for your address.

CP

Kevin DeGraaf wrote:
> I am trying to configure a Polycom IP4000 for use with Asterisk 1.4.5 on
> a flat local network.
> 
> I followed the provisioning guides that I found on the Web, and I have
> the phone downloading bootrom.ld, sip.ld, and a bunch of configuration
> files.  This all works properly.
> 
> However, I receive the following error:
> 
> NOTICE[27345]: chan_sip.c:14725 handle_request_register: Registration
> from '<sip:207 at x.x.x.55>' failed for 'x.x.x.229' - Device does not match ACL
> 
> I can place calls from the IP4000, but I cannot receive them:
> 
> WARNING[27480]: app_dial.c:1106 dial_exec_full: Unable to create channel
> of type 'SIP' (cause 3 - No route to destination)
> 
> Here are the relevant (IMHO) config sections.
> 
> == sip.conf ==
> [ip4000_1]
> mailbox=207 at default
> type=friend
> secret=password
> qualify=yes
> nat=no
> host=dynamic
> canreinvite=no
> 
> == Polycom per-phone config on TFTP server ==
> reg.1.displayName="207"
> reg.1.address="207"
> reg.1.label="207"
> reg.1.type="private"
> reg.1.lcs=""
> reg.1.thirdPartyName=""
> reg.1.auth.userId="ip4000_1"
> reg.1.auth.password="password"
> 
> == Polycom company-wide config on TFTP server ==
> server voIpProt.server.1.address="x.x.x.55"/>
> <SIP>
> <outboundProxy voIpProt.SIP.outboundProxy.address="x.x.x.55"/>
> </SIP>
> 
> I've tried using x.x.x.55 as both the "proxy" value only, the "server"
> value only, and (in the given example) both.
> 
> I also added the following to sip.conf, to no avail:
> 
> deny=0.0.0.0/0.0.0.0
> permit=x.x.x.0/255.255.255.0
> 
> Any ideas about what I've missed would be appreciated.  Thanks.
>