[asterisk-users] g729 on 1.4.10.1

[Scott Moseman]

What's the best way to debug what's going on within Asterisk?
I turned up the 'core debug', but that did not give me what I was
hoping to find.  I'm hoping to see some kind of error that explains
why it will not pass through the g729 codec.

Thanks,
Scott



On 9/14/07, Scott Moseman <scmoseman at gmail.com> wrote:
>
> I have a fresh 1.4.10.1 installation that appears to have a problem
> with g729 pass-through.  I can see the gateway in question sending
> an INVITE using g729b.  However, the Asterisk is only sending g711
> in the INVITE to my Polycom phone.
>
> [gateway]
> disallow=all
> allow=g729
>
> [phone]
> disallow=all
> allow=ulaw
> allow=alaw
> allow=g729
>
> There's the codec configs for the gateway and the phone in question.
> I even attempted to setup the phone with only the allow=g729, but in
> that instance it won't even complete the call.  We had to add g711
> support to the gateway in question for now to get it up and running,
> but we want to get it back to using only g729.
>
> CLI> show modules like g729
> Module                         Description
>  Use Count
> format_g729.so                 Raw G729 data
>  0
> codec_g729a.so                 Annex A/B (floating point) G.729 Codec
> ( 0
> 2 modules loaded
>
> I downloaded the pre-compiled g729 module from Digium.  The sip.conf
> references g729 and the codec module is loaded.  Unless there's
> anything else I need to do that I'm missing?
>
> Thanks,
> Scott
>