[asterisk-users] zaptel upgrade trouble (1.2.10 -> 1.2.20.1)

[Artifex Maximus]

On 10/2/07, Tzafrir Cohen <tzafrir.cohen at xorcom.com> wrote:
> On Tue, Oct 02, 2007 at 10:06:06AM +0200, Artifex Maximus wrote:
> > Hello!
> >
> > I have been trying upgrade zaptel from 1.2.10 to 1.2.20.1. I am using
> > asterisk 1.2.10 with one TDM2400P (all 6 module in use) and one
> > TE405P. When I upgrade to 1.2.20.1 the order of cards mess up and
> > therefore zaptel.conf is unusable and gives error. Why is it happen
> > and what do I need to change in zaptel.conf?
> >
> > now zaptel.conf is:
> > loadzone=hu
> > defaultzone=hu
> > # GSM
> > fxsks=1-4
> > # FAX
> > fxoks=5-8
> > # EXT
> > fxoks=9-24
> > # PRI
> > span=2,1,0,ccs,hdb3,crc4
> > bchan=25-39
> > dchan=40
> > bchan=41-55
> >
> > zttool shows that my TDM is the first device and T4XXP is from second
> > to fifth. Nice. After zaptel upgrade TDM is on the fifth position. And
> > channels in zaptel.conf were messed up of course because 1-24 is not
> > for TDM.
>
> Was there also a change in the kernel ?
>
> In the value of MODULES in /etc/{sysconfig,default}/zaptel ?
Thanks for your answer. Same kernel (2.6.11) and no change in zaptel:

MODULES="$MODULES wct4xxp"      # TE405P - Quad Span T1/E1 Card (5v version)
MODULES="$MODULES wctdm24xxp"   # TDM2400P - Modular FXS/FXO interface
(1-24 ports)

Might MODULES order count? If so why that wasn't count with zaptel 1.2.10?

I have unload zaptel, remove directory /lib/modules/<kernel>/misc and
run "depmod -a" before upgrading. Check and replace /etc/init.d/zaptel
with the new one. And reboot finally.

bye,
a