[asterisk-users] Module wctdm24xxp not found - TDM808P on debian

[William Moore]

On 5/11/07, Juliano Fernandes Schroeder <juliano7s at gmail.com> wrote:
> I'm trying to configure a TDM808P card on debian. When I modprobe wctdm24xxp
> i get this error
> FATAL: Module wctdm24xxp not found.
> FATAL: Error running install command for wctdm24xxp
>
> I think i have successfully compiled the zaptel drivers, and the card
> appears when i do a lspci
>
> 02:06.0 Ethernet controller: Digium, Inc. Unknown device 0800 (rev 11)
>         Subsystem: Digium, Inc. Unknown device 0800
>         Flags: bus master, medium devsel, latency 64, IRQ 3
>         I/O ports at e800 [size=256]
>         Memory at fe200000 (32-bit, non-prefetchable) [size=1K]
>         Expansion ROM at 20000000 [disabled] [size=128K]
>         Capabilities: [c0] Power Management version 2
>
> I've searched for a solution with no success. Another problem is that when i
> do a ztcfg -vv i get
>
> Notice: Configuration file is /etc/zaptel.conf
> line 0: Unable to open master device '/dev/zap/ctl'
>
> 1 error(s) detected
>
> I don't know if the errors are connected and would appreciate some help.

Did you "make install" in the zaptel source directory?  If you didn't,
it didn't put the kernel modules in your kernel's module directory and
run depmod, so your system doesn't know about the modules.