[asterisk-users] Zap failure: cause 66 - Channel not implemented

[Sanjay Rajdev]

Which version of Zaptel and Asterisk are you using.

If you have compiled Asterisk 1.4.2 with Zaptel 1.4.0 or a lesser version of Zaptel, you may face this problem.


Regards,
Sanjay Rajdev

----- Original Message -----
From: "Greg Woods" <greg at gregandeva.net>
To: "Asterisk Users Mailing List - Non-Commercial Discussion" <asterisk-users at lists.digium.com>
Sent: Friday, April 13, 2007 9:29:43 PM (GMT+0530) Asia/Calcutta
Subject: Re: [asterisk-users] Zap failure: cause 66 - Channel not implemented

On Fri, 2007-04-13 at 07:46 +0200, Jose Limeres wrote:
> when I try to make a call through the ZAP
> channel get an error message about NO ZAP CHANNEL AVAILABLE. Ztcfg and
> zttool show the card correctly installed.

> When I tried to use the debug command ZAP SHOW, it was not present in
> the CLI.

This almost surely means that when you compiled asterisk, it did not
detect that you had the Zaptel drivers. I had this happen to me and I
beat my head against the wall for quite a while before I figured it out.
You must compile and install the zaptel driver first, then compile
asterisk.

--Greg


_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --

asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users