[asterisk-users] Zap failure: cause 66 - Channel not implemented

[Greg Woods]

On Fri, 2007-04-13 at 07:46 +0200, Jose Limeres wrote:
> when I try to make a call through the ZAP
> channel get an error message about NO ZAP CHANNEL AVAILABLE. Ztcfg and
> zttool show the card correctly installed.

> When I tried to use the debug command ZAP SHOW, it was not present in
> the CLI.

This almost surely means that when you compiled asterisk, it did not
detect that you had the Zaptel drivers. I had this happen to me and I
beat my head against the wall for quite a while before I figured it out.
You must compile and install the zaptel driver first, then compile
asterisk.

--Greg