[Asterisk-Users] TDM4xxP

[Steve Totaro]

Steve Totaro wrote:
> Roger Gulbranson wrote:
>> On Thu, 2006-05-11 at 11:13 -0400, Steve Totaro wrote:
>>
>>  
>>> I was able to install the card and get wctdm to load with the 
>>> timingonly = 1 setting.
>>> I cannot run ./zttest though, I get "Unable to open zap interface: 
>>> No such device or address" Does this mean that I am not getting timing?
>>>     
>>
>> Is this a 2.6 kernel?  You may need to configure the /dev/zap
>> interfaces.
>>
>>  
>>> Do I actually have to configure any of the conf files at all or 
>>> should modprobe zaptel, modprobe wctdm without errors be enough.
>>>     
>>
>> It *should* be enough (my comments above withstanding).  NB: I was doing
>> this on SPARC Solaris -- there are numerous differences which could
>> affect you.
>>
>>
>>   
> It is CentOS 2.6.9-34.EL SMP
>
> Is there something in particular I have to configure based on below?
>
> [root at asterisk01 ~]# cd /dev/zap/
> [root at asterisk01 zap]# ls -la
> total 0
> drwxr-xr-x  2 root     root          120 May 11 07:15 .
> drwxr-xr-x  9 root     root         4580 May 11 07:15 ..
> crw-rw----  1 asterisk asterisk 196, 254 May 11 07:15 channel
> crw-rw----  1 asterisk asterisk 196,   0 May 11 07:15 ctl
> crw-rw----  1 asterisk asterisk 196, 255 May 11 07:15 pseudo
> crw-rw----  1 asterisk asterisk 196, 253 May 11 07:15 timer
> [root at asterisk01 zap]#
>
> _______________________________________________
>
OK fixed it now, can confirm a TDM4XXP card with no modules can provide 
timing.  I had to remove the loaded modules and then modprobe them 
again, at which point timing worked just fine.

Thanks,
Steve