[Asterisk-Users] How to assign channels for asterisk

[Melcon Moraes]

Hi,

zapata.conf and zaptel.conf has different sintaxes. In zaptel.conf, you 
should use only:

fxsks=3-4

The zapata.conf of yours seems to be ok, but I don't see the group=1 on 
it. And that "-- Executing Dial" stuff has nothing to do with receiving 
a call from PSTN.

[]'s
MM

bixbite at tom.com wrote:
> 
>   helleo ,I have one wildcard installed on the server,and configured it.there are  
>  two modules which both FXOs .all configurations complete,and when we start asterisk use "asterisk -vvvvc",it shows asterisk ready,no warnings.afterwards when the sever connected to the PSTN in the one port which configured,and have a  phone line connected to the other port then run "zttool",however it shows just one channel active.I can't understand ,why? I try to dial the PSTN number from another external phone to test,but the call is not ringing.But in the asterisk cLI there  are some infos following as :
>     -- Starting simple switch on 'Zap/4-1'
>     -- Executing Dial("Zap/4-1", "Zap/g1") in new stack
> those are my configurations:
>  -extension.conf--
> [incoming]
> exten => s,1,Answer()
> exten => s,2,Echo()
>  -zapata.conf--
> context=incoming
> signalling=fxs_ks
> channel => 3-4
>   -zaptel.conf
> context=incoming
> signalling=fxs_ks
> channel => 3-4
>  hope to hear from you
> thanks & regards
> 
> --
> This message was sent on behalf of bixbite at tom.com at openSubscriber.com
> http://www.opensubscriber.com/messages/asterisk-users@lists.digium.com/topic.html
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com --
> 
> Asterisk-Users mailing list
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users
> 
>