[asterisk-users] X100P clone not working

[Frank Darner]

Tzafrir Cohen:
> On Sat, Jul 22, 2006 at 09:02:48PM +0200, Frank Darner wrote:
> > Hi,
> >
> > I have problem to set up an X100P clone card.
> > Installation of zaptel was successful.
> > Also modprobe of zaptel, ztdummy and wcfxo without problems.
> >
> > kernel: wcfxo: module not supported by Novell, setting U taint flag.
> > kernel: ACPI: PCI Interrupt 0000:05:04.0[A] -> GSI 16 (level, low) -> IRQ
> > 193 kernel: wcfxo: DAA mode is 'FCC'
> > kernel: Found a Wildcard FXO: Generic Clone
> > kernel: Registered tone zone 0 (United States / North America)
> >
> >
> > But if I do #ztcfg -vvv no channels will be found.
>


Hi,

OK, I do # modprobe zaptel && modprobe wcfxo


> What is the exact output from that command?

linux:/proc/zaptel # ztcfg -vvv
Zaptel Configuration
======================
Channel map:
0 channels configured.

>
> What is the output from 'cat /proc/zaptel/*'

nothing

dir /proc/zaptel but is empty

BUT, if I do additional  # modprobe ztdummy

linux:/proc/zaptel # cat /proc/zaptel/*
Span 1: ZTDUMMY/1 "ZTDUMMY/1 1"

any ideas ?

thanks