[asterisk-users] X100P clone not working

[Tzafrir Cohen]

On Sat, Jul 22, 2006 at 09:02:48PM +0200, Frank Darner wrote:
> Hi,
> 
> I have problem to set up an X100P clone card.
> Installation of zaptel was successful.
> Also modprobe of zaptel, ztdummy and wcfxo without problems.
> 
> kernel: wcfxo: module not supported by Novell, setting U taint flag.
> kernel: ACPI: PCI Interrupt 0000:05:04.0[A] -> GSI 16 (level, low) -> IRQ 193
> kernel: wcfxo: DAA mode is 'FCC'
> kernel: Found a Wildcard FXO: Generic Clone
> kernel: Registered tone zone 0 (United States / North America)
> 
> 
> But if I do #ztcfg -vvv no channels will be found.

What is the exact output from that command?

What is the output from 'cat /proc/zaptel/*'

-- 
Tzafrir Cohen         sip:tzafrir at local.xorcom.com
icq#16849755          iax:tzafrir at local.xorcom.com
+972-50-7952406          jabber:tzafrir at jabber.org
tzafrir.cohen at xorcom.com     http://www.xorcom.com