[Asterisk-Users] linksys pap2 automatically connect on liftinghandset

[John Millican]

On Friday January 13 2006 10:14 pm, James Harper wrote:
> The best I can do so far (which appears to be a bit of a hack) is
> (<:0>S0), which says to add a '0' to the start of the string and dial
> immediately. This gives asterisk an extension dialled of '0', which
> isn't the 's' that i'd hoped for, but is a good start!
>
> (S0) by itself doesn't work, nor does (<:>S0).
>
> Any other suggestions?
>
> Thanks
>
> James
>
> > -----Original Message-----
> > From: asterisk-users-bounces at lists.digium.com [mailto:asterisk-users-
> > bounces at lists.digium.com] On Behalf Of James Harper
> > Sent: Saturday, 14 January 2006 13:31
> > To: Asterisk Users Mailing List - Non-Commercial Discussion
> > Subject: [Asterisk-Users] linksys pap2 automatically connect on
> > liftinghandset
> >
> > Is there a way to configure the linksys pap2 to automatically connect
>
> to
>
> > asterisk on lifting the handset (presumably into the 's' state)?
> > Asterisk would then be listening for DTMF tones to figure out what to
>
> do
>
> > rather than having to put a dial plan into each pap2.
> >
> > I think the pap2 is pretty much the same inside as a few of the sipura
> > boxes so the same thing might work if anyone knows...
> >
> > Thanks
> >
> > James
Create an extension that will catch what ever number you put into the PAP2 as 
(SO<:Extension_in_Asterisk)
This provides a hot line setup per the documentation for a SPA-3000 which I 
believe has the same dial plan execution as the PAP2, at
least all the stuff i did on one worked on the other.
John M