[Asterisk-Users] Cannot boot machine up after working on zapt el....

[Colin Anderson]

What happens if you take out the Zaptel I/F's? If it boots, you can correct
whatever you did then replace them. 

hth

-----Original Message-----
From: Chris Earle (CBL) [mailto:cearle at cbltech.ca]
Sent: Tuesday, February 28, 2006 7:45 AM
To: asterisk-users at lists.digium.com
Subject: [Asterisk-Users] Cannot boot machine up after working on
zaptel....


Hi all,

hard for me to explain this, but it keeps happening on a number of machines

I attempt to upgrade zaptel, or do something to zaptel modules..... and then
I reboot the machine, and for whatever reason, it hangs on loading the
modules

Either the install wasn't complete, the zaptel modules settings are wrong,
whatever....
but the problem is now I can't get past the boot up and the machine is
basically lost

Is there any way to bypass the module load attempt or anything?

I've tried holding SHIFT down to get the LILO menu, and loading LinuxOLD,
but no go

I'm on Debian 2.4.18, with Zaptel 1.0.9.2

I understand that there was something wrong in the modules config, but
surely I should be able to bypass and get back in to fix it!

Any ideas greatly appreciated, as I would rather not have to use an old
clone drive and start over


--
Chris Earle
System Solutions Specialist


-- 
This message has been scanned for viruses and dangerous content by
MailScanner, and is believed to be clean.

_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --

Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users