[Asterisk-Users] problem with outgoing calls Unabletocreatechannel of type 'ZAP' (cause 34 - Circuit/channel congestion)

[nik600]

On 2/14/06, Michael Collins <mcollins at fcnetwork.biz> wrote:
> Nik,
>
> I'm not sure that "NOP" is correct, but I'm in the states so I'll to
> defer to someone who knows E1/PRI.  When I run zttool I have "OK" under
> the alarms.  Is there a way you can call the telco and confirm the
> settings?  Make sure that framing, coding and D channels are set up on
> their end the same way you're set up.
>
ok, with your configuration incoming calls works, but:

- i have eco (maybe i have to increase/decrease echotraining value?)
- outgoing calls doesn't works (

    -- Executing Dial("SIP/102-cc9b", "ZAP/g0/mynumber") in new stack
  == Everyone is busy/congested at this time (1:0/1/0)
    -- Executing Goto("SIP/102-cc9b", "s-CONGESTION|1") in new stack
    -- Goto (macro-dialout-trunk,s-CONGESTION,1)
    -- Executing NoOp("SIP/102-cc9b", "Dial failed due to CONGESTION")
in new stack
    -- Executing Macro("SIP/102-cc9b", "outisbusy") in new stack
    -- Executing Playback("SIP/102-cc9b", "all-circuits-busy-now") in new stack

)
it seems that i don't have any channel for outbound
- ALARM is set on NOP

i've got a TE205P and my zaptel.conf is:

span=1,0,0,ccs,hdb3,crc4,yellow
span=2,0,0,ccs,hdb3,crc4,yellow

bchan = 1-15, 17-31
dchan = 16
bchan = 32-46,48-62
dchan = 47

loadzone        = it
defaultzone     = it