[asterisk-users] Need help getting started with asterisk

[Tzafrir Cohen]

On Mon, Dec 18, 2006 at 02:10:23PM -0600, Michael Sullivan wrote:
> On Wed, 2006-12-13 at 14:21 +1100, Paul Hales wrote:
> > I would be very surprised if your modem is supported by Asterisk - but I
> > suppose it's worth a try.
> > 
> > What does 'zap show status' and 'zap show channels' show in the Asterisk
> > CLI?
> > 
> > PaulH
> 
> OK.  I got the Motorola X100P put in:
> 
> Relevant lspci -v output:
> 
> 05:01.0 Communication controller: Motorola Wildcard X100P
>         Subsystem: Motorola Unknown device 0000
>         Flags: bus master, medium devsel, latency 32, IRQ 22
>         I/O ports at b800 [size=256]
>         Memory at ff900000 (32-bit, non-prefetchable) [size=4K]
>         Capabilities: [40] Power Management version 2
> 
> 
> However, although I can modprobe wctdm successfully, ztcfg still balks:
> 
> camille ~ # modprobe wctdm

You need the module wcfxo. But maybe it was hotplugged/

> camille ~ # /sbin/ztcfg -vv
> 
> Zaptel Configuration
> ======================
> 
> 
> Channel map:
> 
> Channel 02: FXS Kewlstart (Default) (Slaves: 02)

02? Are you sure?

> 
> 1 channels configured.

That is: this is what ztcfg tries to do.

> 
> ZT_CHANCONFIG failed on channel 2: No such device or address (6)

But it fails.

> 
> 
> "zap show channels" comes back with encouraging results though:
> 
> camille*CLI> zap show channels
>    Chan Extension  Context         Language   MusicOnHold         
>  pseudo            default                                        
> 
> 
> Do I need to moprobe something else or alter my kernel config for ztcfg
> not to error?
> -Michael Sullivan-

What do you see on /proc/zaptel/*

Try genzaptelconf ...

-- 
               Tzafrir Cohen       
icq#16849755                    jabber:tzafrir at jabber.org
+972-50-7952406           mailto:tzafrir.cohen at xorcom.com       
http://www.xorcom.com  iax:guest at local.xorcom.com/tzafrir