R: [Asterisk-Users] PRI value

[Giordano Grandis]

Perfect, thanks very much hth. I just set it to unknown, but it doesn't work.

 

Have I to use also prilocaldialplan ?

 

Thanks again

 

Giordano

________________________________

Da: asterisk-users-bounces at lists.digium.com [mailto:asterisk-users-bounces at lists.digium.com] Per conto di Colin Anderson
Inviato: giovedì 29 settembre 2005 16.22
A: 'Asterisk Users Mailing List - Non-Commercial Discussion'
Oggetto: RE: [Asterisk-Users] PRI value

 

PRI dialplan, in a nutshell, sets dialled digits from your Asterisk box to a pattern that your telco expects. For example, if your telco expects numbers in XXX-XXXX format ALWAYS, then you would set it to Local so the MSD of whatever your user dials is stripped off by Asterisk, leaving only a pattern that the PRI expects. 99% of the time, you want to set this to "unknown" and this will allow your Asterisk box to send the digits unaltered to the PRI which is what you want.

 

I see you are in Europe so I can't comment on the numbering pattern your telco expects there, but I suspect that "unknown" will work fine for you here. However, it should be explicitly set and not ignored, if only to "unknown"

 

hth

 

 

	-----Original Message-----
	From: Giordano Grandis [mailto:g.grandis at invidea.it]
	Sent: Thursday, September 29, 2005 2:11 AM
	To: Asterisk Users Mailing List - Non-Commercial Discussion
	Subject: [Asterisk-Users] PRI value

	Hi group,

	anyone can explain me the exact difference between pri value in zapata.conf ?

	 

	; PRI Dialplan:  Only RARELY used for PRI.
	;
	; unknown:        Unknown
	; private:        Private ISDN
	; local:          Local ISDN
	; national:       National ISDN
	; international:  International ISDN

	 

	If I use it, I also must use prilocaldialplan = local ?

	 

	Thanks

	 

	Giordano

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-users/attachments/20050929/c569475a/attachment.htm