[Asterisk-Users] TE405P V2 changes?

[Rod Bacon]

Did you find a solution to this?


Kib Eki wrote:
> yes, fedora 3 but without any changes at the sources
> 
> Master Abi wrote:
> 
>> Are you using Redhat/Fedora? If I remember those init scripts is for 
>> Redhat/Fedora. I am using gentoo.
>>
>> Did you make any modifications to wct4xxp.c. or pass any parameters to 
>> zaptel. I see there is a #define SUPPORT_GEN1 in to wct4xxp.c which I 
>> commented out, but it made no difference. ztcfg seems to where the 
>> channels become unassigned.
>>
>> Thanks again.
>>
>> Kib Eki wrote:
>>
>>> Hi,
>>> we also got one V2 TE405P card. It works fine now. At the moment we 
>>> use for bridging the Pri to our old PBX.
>>> You must use zaptel, libri and asterisk v 1.0.8 or higher. We use 
>>> 1.0.9 at the moment.
>>> zaptel:
>>> after make; make install i also executed make config. This copies the 
>>> correct startup script to /etc/init.d/zaptel. Without this it also 
>>> didn't worked for me.
>>>
>>>
>>>
>>> Master Abi wrote:
>>>
>>>> Hi
>>>>
>>>> I got the 2nd Gen firmware upgraded on the TE405P.  I recompiled 
>>>> after putting in the upgraded board but did not change any conf, but 
>>>> the spans become active but will not come up.
>>>>
>>>> I guess I am missing something or are the any changes to the 
>>>> zaptel/libpri software that is required. I cannot find any info 
>>>> about this or does this new firmware only work with latest CVS. I am 
>>>> using 1.0.9 with 2.6.12 kernel
>>>>
>>>> Zapata Telephony Interface Registered on major 196
>>>> Found TE4XXP at base address fdfff000, remapped to f8928000
>>>> TE4XXP version c01a0164, burst ON, slip debug: OFF
>>>> TE4XXP running with work queues.
>>>> FALC version: 00000005, Board ID: 00
>>>> Reg 0: 0x364e9400
>>>> Reg 1: 0x364e9000
>>>> Reg 2: 0xffffffff
>>>> Reg 3: 0x00000000
>>>> Reg 4: 0x00000001
>>>> Reg 5: 0x00000000
>>>> Reg 6: 0xc01a0164
>>>> Reg 7: 0x00001f00
>>>> Reg 8: 0x00000000
>>>> Reg 9: 0x00ff0000
>>>> Reg 10: 0x00000000
>>>> TE4XXP: Launching card: 0
>>>> TE4XXP: Setting up global serial parameters
>>>> Found a Wildcard: Wildcard TE405P (2nd Gen)
>>>> eth0: link up, 10Mbps, half-duplex, lpa 0x0000
>>>> About to enter spanconfig!
>>>> Done with spanconfig!
>>>> About to enter spanconfig!
>>>> Done with spanconfig!
>>>> Unassigning channel 0/1!
>>>> Unassigning channel 0/2!
>>>> Unassigning channel 0/3!
>>>> Unassigning channel 0/4!
>>>> Unassigning channel 0/5!
>>>> Unassigning channel 0/6!
>>>> Unassigning channel 0/7!
>>>> Unassigning channel 0/8!
>>>> Unassigning channel 0/9!
>>>> Unassigning channel 0/10!
>>>> Unassigning channel 0/11!
>>>> Unassigning channel 0/12!
>>>> Unassigning channel 0/13!
>>>> Unassigning channel 0/14!
>>>> Unassigning channel 0/15!
>>>> Unassigning channel 0/16!
>>>> Unassigning channel 0/17!
>>>> Unassigning channel 0/18!
>>>> etc...
>>>>
>>>> This was working for 10 months before the upgrade.
>>>>
>>>> Master
>>>>
>>>>
>>>> _______________________________________________
>>>> Asterisk-Users mailing list
>>>> Asterisk-Users at lists.digium.com
>>>> http://lists.digium.com/mailman/listinfo/asterisk-users
>>>> To UNSUBSCRIBE or update options visit:
>>>>   http://lists.digium.com/mailman/listinfo/asterisk-users
>>>>
>>>>
>>>
>>> _______________________________________________
>>> Asterisk-Users mailing list
>>> Asterisk-Users at lists.digium.com
>>> http://lists.digium.com/mailman/listinfo/asterisk-users
>>> To UNSUBSCRIBE or update options visit:
>>>   http://lists.digium.com/mailman/listinfo/asterisk-users
>>>
>> _______________________________________________
>> Asterisk-Users mailing list
>> Asterisk-Users at lists.digium.com
>> http://lists.digium.com/mailman/listinfo/asterisk-users
>> To UNSUBSCRIBE or update options visit:
>>   http://lists.digium.com/mailman/listinfo/asterisk-users
>>
>>
> 
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>   http://lists.digium.com/mailman/listinfo/asterisk-users
> 
>