[Asterisk-Users] Sipura SPA-3000 setup in Brazil

[Ossi Sariola]

Paul,
 
I have been using a SPA-3000 here in São Paulo, and after some tweaking it
is working ok.
 
I do recall that I had to set some line parameters due to the differences,
but I need to open the configs of the ATA again
 
 
Meanwhile, if you have any additional info let me know, I might be able to
help

 
Cheers,
 
oZ
 
 
  ----- Original Message ----- 
  From: Paul Davidson 
  To: Asterisk Users Mailing List - Non-Commercial Discussion 
  Sent: Wednesday, October 05, 2005 8:25 PM
  Subject: [Asterisk-Users] Sipura SPA-3000 setup in Brazil
 
 
  All-
 
  I'm attempting to set up a Sipura SPA-3000 in Sao Paolo, Brazil.  Not
being a portuguese speaker, I'm having a rough time of finding the relevant
information on how to make the thing pick up the PSTN line and make an
outbound call.
 
  The sipura in question works fine on a bench connected to a POTS line in
the US, but is now plugged in in Sao Paolo.  The immediate thing I notice is
that the voltage is high by US standards- 66v, as opposed to 48.  But no
combination of settings will seem to make it work properly- attempted
outbound calls generate dead air.  A brazilian POTS phone hooked up to the
FXS port on the unit works just fine- I can ring it, and it can call into
Asterisk.
 
  Am I barking up the wrong tree, and does the device have to be different
for it to work in Brazil, or is there some magic I need to apply to the
Sipura config to make it work?
 
  Any previous experience shared would be welcomed, and eventually,
published on the wiki.
 
  -pbd

 

 

 

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-users/attachments/20051112/ed4e454e/attachment.htm