[Asterisk-Users] Re: Dell 1750 & TDM400P - Power

[Adam Robins]

I think that the best solution I found is to use a standard ATX power
supply externally and jumper/switch the green and black connectors on
the 20-pin Molex connector to simulate the case/motherboard power
switch.  I can then snake in the output power cable with the 4-pin
connector to the TDM400P.

Anyone think this won't work?

-----Original Message-----
From: asterisk-users-bounces at lists.digium.com
[mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Bill
Carroll
Sent: Tuesday, March 29, 2005 4:34 PM
To: asterisk-users at lists.digium.com
Subject: [Asterisk-Users] Re: Dell 1750 & TDM400P - Power

Adam,

I've used an SCA 80-pin to SCSI HD68 adapter that also breaks out a
standard power connector. You'll also need a short SCA cable to connect
the adapter to the SCA connector as well as a standard power cable to
connect between the adapter and the TDM400P. Just google for SCA SCSI
adapter and you'll find lot's of places have these things. This assumes
that you aren't using all of your hot-swap drive bays.

Bill

> 
>  
> Has anyone come up with a way to get power to a TDM400P card installed

> in a Dell PowerEdge 1750?
> 
> Thanks,
> Adam
> 
_______________________________________________
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users

The contents of this email message and any attachments are confidential and are intended solely for addressee. The information may also be legally privileged. This transmission is sent in trust, for the sole purpose of delivery to the intended recipient. If you have received this transmission in error, any use, reproduction or dissemination of this transmission is strictly prohibited. If you are not the intended recipient, please immediately notify the sender by reply email and delete this message and its attachments, if any.