[Asterisk-Users] More on W6692pci NT mode under chan_misdn

[Konrads Smelkovs]

So far i've grasped that to use a card in NT mode it should have
layermask=3 as module option. Is it the only thing that sets TE or NT
mode for card? Perhaps there are settings in misdn.conf ? I can only
get the card to work in TE mode and even then when asterisk is ran as
asterisk -vvvgc it exits right after chan_misdn is loaded with theese
messages:

 [chan_misdn.so] => (Channel driver for mISDN Support (Bri/Pri))
  == Parsing '/etc/asterisk/misdn.conf': Found
UnLocking config_mutex
  == Registered channel type 'mISDN' (This driver enables the asterisk
to use hardware which is supported by the new )
debug_init: using stdout for debug log
debug_init: using stderr for warning log
debug_init: using stderr for error log
debug_init: debug_mask = 0
Locking Config Mutex
UnLocking Config Mutex
Init. Stack on port:1
TE Stack
No lower Id port:1
init_stack: Success
talkinghead:~ # 
syslog: Feb 18 16:58:50 talkinghead kernel: MISDN free_device:
entitylist not empty
in misdn.conf there is
[NT cards]
context=outgoing
ports=1

with ports=1ptp it Segfaults.


Clues?

-- 
Konrads Smelkovs
Applied IT sorcery.