[Asterisk-Users] ztcfg doesn't do anything from /etc/rc.d/rc.local

[Remco Barende]

When using bristuff I do get an error too if I don't load zaptel first but 
not with the tdm driver.

I know that in my modprobe.conf it is specified that ztcfg should be run 
after loading the module but.... why doesn't it?

For some reason ztcfg is only 'accepted' when run from the cli

Thanks!


On Sat, 23 Apr 2005, Chris wrote:

>   *sigh*
>
>    I always get an error if I don't.
>
> Regards,
>
> Chris
>
> ----- Original Message -----
> From: "Eric Wieling aka ManxPower" <eric at fnords.org>
> To: "Asterisk Users Mailing List - Non-Commercial Discussion" <asterisk-users at lists.digium.com>
> Sent: Saturday, April 23, 2005 7:15 PM
> Subject: Re: [Asterisk-Users] ztcfg doesn't do anything from /etc/rc.d/rc.local
>
>
>> Chris wrote:
>>
>>> You need this before wcfxs
>>>
>>> /sbin/modprobe zaptel
>>
>> *sigh*
>>
>> zaptel will automatically load when the card driver loads.
>>
>> modporbe will also run ztcfg after loading the card driver because (if
>> you ran "make install") /etc/modules.conf tells it to do so.
>>
>> --
>> Always do right. This will gratify some people and astonish the rest.
>> Mark Twain
>> _______________________________________________
>> Asterisk-Users mailing list
>> Asterisk-Users at lists.digium.com
>> http://lists.digium.com/mailman/listinfo/asterisk-users
>> To UNSUBSCRIBE or update options visit:
>>    http://lists.digium.com/mailman/listinfo/asterisk-users
>>