[Asterisk-Users] TDM400P lockups (FXO)

[Richard Scobie]

Maciej Kietlinski wrote:
>>>Are the FXOs on the 2x on ports 1-2 or 3-4?  Maybe it has to 
>>>do with *any* FXO on port 1...
>>>
>>>Please get back with the list with your findings.
>>>
>>
>>
>>My experience led to a replacement from Digium, but the card is a
>>TDM400P with 4 FXO...now that I think of it, during troubleshooting
>>there was some correlation to the first port on the card (port 1)...not
>>the first module - I swapped module positions to varying locations on
>>the card without success, but then again they are all FXO...Maybe *is*
>>possible that the TDM400P doesn't like an FXO module in port 1 as you
>>are suggesting...Like I said, in the end I got a new revision board from
>>digium, all 4 ports are still FXO and working great now...
>>
> 
> 
> With my old revision TDM400P it was the same problem with 
> FXO on port 1. Easiest way for me was to put FXO's on new 
> revision card, and on old use FXS on port 1.
> 
> I used info from post with:
> 'The card had been modified, evident from the jumper wire that been 
> soldered between two points on the back of the card. I haven't had 
> problems since installing the new card.'
> And before old card was used with FXS + 3 x FXO without problems,
> so it works in the same hw conf again.
> 
> Now I heve no problems with TDMxxp

I'll let you know how I get on. One of the cards that is giving trouble, 
has FXOs in positions 3 and 4.

Can anyone tell me what these "new revision" cards are? My current ones 
are all Rev. E/F.

Regards,

Richard