[Asterisk-Users] Can't install the mfcr2 support correctly

[Abdelghani Khaled]

Hi Mr Jack, hi everybody

Thank you for your answer for my message titled "can't run ztcfg". I tried 
what you proposed me and the error I told about is not signaled. However I 
still have problems to get mfc/r2 support running.

I refered to the mfcr2 support documentation available in the opencall.org 
website http://www.opencall.org/installing-mfcr2.html .

The digium card I have is the TE410P

After installing the zaptel driver using the following commands:

make clean
make install
make config

After adding the necessary lines to the zaptel.conf file.

The problem is that when I execute the following command :

modprobe wct4xxp

which is necessary to run ztcfg correctly (as you told me) I get the 4 ports 
lights of the card off.
Yesterday I got them red.

And when I connect an E1 to a port I don't get a green light but I get 
either a red light (or no light at all) if the light was already red or no 
light if the light was already off.

I hope that my message is clear and that someone will help me.

_________________________________________________________________
MSN Hotmail : antivirus et antispam intégrés 
http://www.msn.fr/newhotmail/Default.asp?Ath=f