[Asterisk-Users] Re: Using AVM C4 with fewer than four lines?

[Carl Sempla]

On Thursday, 28 October, 2004 14:08 : Louis van Dompselaar
<lvandompselaar at sitebysite.nl> wrote:

>> I think changing devices=4 to devices=2 in capi.conf should do the
>> trick. Of course you have to make sure that your ISDN lines are
>> connected to the two ports that haven't been disabled.
>>
> It's already at devices=2 but that doesn't make a difference.
> I think chan_capi sees the C4 as one single device with four
> controllers.
>
> Anyway, the current capi.conf has devices=2 (tried 4 and 1; doesn't
> matter) and controller=1 (tried 1, 2 and 1,2,3,4, doesn't matter).  I
> always get:

If your devices= is to low, for example =1, then when you receive a 2nd
call, you'll get the following error :
ERROR [3075]: chan_capi.c:1696 capi_handle_msg: did not find device for msn
= 1234xxx and the caller get a busy signal.

-- 
Carl