[Asterisk-Users] TDM400P hardware problems

[Bartosz Jozwiak]

----- Original Message ----- 
From: "Cirelle Enterprises" <gcirino at cirelle.com>
To: "Asterisk Users Mailing List - Non-Commercial Discussion"
<asterisk-users at lists.digium.com>
Sent: Thursday, October 28, 2004 12:15 PM
Subject: Re: [Asterisk-Users] TDM400P hardware problems



----- Original Message ----- 
From: "Bartosz Jozwiak" <bartek at cq-link.sr>
To: <asterisk-users at lists.digium.com>
Sent: Thursday, October 28, 2004 10:55 AM
Subject: [Asterisk-Users] TDM400P hardware problems


| Dear All,
|
| I am using TDM400P card for about 4 months right now with
| 4 FXO modules.
| During this 4 months of use I needed to shutdown server (power off)
becuase
| the card just stopped working.
| The card did not picked up calls, on console there is nothing.
| Shutting down asterisk does not help or loding drivers again.
| The server has to be powerd off and then turned on again.
|
| Could it be hardware (TDM400P) problem ?
| Did somebody notice the same problems ?
|
| Bartosz
| _______________________________________________

I was just going to ask if this has been fixed yet....

I have the exact same card, hasn't worked properly yet (with
respect to the reboot situation).

the same behaviour happens with zaptel channels configured or not

what version of the zaptel drivers are you using?
Greg

_______________________________________________

I have just installed Asterisk and Zaptel 1.0.2
So I will see if this helps.
Sometimes I even here "clicking" noise and I need to power off server
then everything goes back to normal. My server is Dell.

Bartosz