[Asterisk-Users] Digium Wildcard T1 Compatibility

[Steve Underwood]

Cirelle Enterprises wrote:

>----- Original Message ----- 
>From: "Steve Totaro" <asterisk at totarotechnologies.com>
>To: "Asterisk Users Mailing List - Non-Commercial Discussion" <asterisk-users at lists.digium.com>
>Sent: Monday, October 25, 2004 9:32 AM
>Subject: Re: [Asterisk-Users] Digium Wildcard T1 Compatibility
>
>
>| Out of curiousity, would you mind sharing what you have tried?
>| 
>
>from a previous post...
>
>T1 provider info
>HDLC 24 channel
>160.81.118.46/30 (my side)
>160.81.118.45/30 (sprint)
>
>
># ifconfig
>hdlc0     Link encap:(Cisco)-HDLC  
>          inet addr:160.81.118.46  P-t-P:160.81.118.45  Mask:255.255.255.252
>          UP POINTOPOINT RUNNING MULTICAST  MTU:1500  Metric:1
>          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>          TX packets:1399 errors:0 dropped:0 overruns:0 carrier:0
>          collisions:0 txqueuelen:50 
>          RX bytes:0 (0.0 b)  TX bytes:40388 (39.4 Kb)
>
>lo        Link encap:Local Loopback  
>          inet addr:127.0.0.1  Mask:255.0.0.0
>          UP LOOPBACK RUNNING  MTU:16436  Metric:1
>          RX packets:3468 errors:0 dropped:0 overruns:0 frame:0
>          TX packets:3468 errors:0 dropped:0 overruns:0 carrier:0
>          collisions:0 txqueuelen:0 
>          RX bytes:141932 (138.6 Kb)  TX bytes:141932 (138.6 Kb)
>
>
>commands to achieve the above:
>
>/sbin/modprobe zaptel
>/sbin/modprobe wct1xxp
>/sbin/modprobe hdlc
>/sbin/ztcfg
>/sbin/sethdlc hdlc0 cisco 
>/sbin/ifconfig hdlc0 arp multicast 160.81.118.46 pointopoint 160.81.118.45 netmask 255.255.255.252
>/sbin/route add default gw 160.81.118.45 netmask 0.0.0.0  dev hdlc0
>
>/proc/sys/net/ipv4/ip_forward = 1
>
>sysctl.conf:
># Controls IP packet forwarding
>net.ipv4.ip_forward = 1
>
>/etc/sysconfig/network:
>NETWORKING=yes
>HOSTNAME=ast.cirelle.com
>IPV4_FORWARD=yes
>GATEWAY=
>
>iptables, accepts in all directions (no firewalling)
>
>zaptel.conf:
>span=1,1,5,esf,b8zs
>nethdlc=1-24
>loadzone = us
>defaultzone=us
>
>
>zapata.conf
>switchtype = national
>signalling = pri_cpe
>loadzone=us
>defaultzone=us
>  
>
If you want to use the whole T1 for HDLC, why have you configured it as 
an ISDN PRI line?

Steve