[Asterisk-Users] linking 2 isdn30 and 2 meridian cards

Peter Svensson psvasterisk at psv.nu
Wed Nov 24 00:33:35 MST 2004


On Tue, 23 Nov 2004, Asterisk wrote:

> At the moment, I have the following working scenario:
> 
> isdn30B->(1)te410p(2)->merdian(B)
> isdn30A->meridian(a)->te410p(2)
> 
> IOW, two isdn30 lines, one going to * span 1, the other going to the
> meridian (pri card a), which then is connected to * by pri card (B) into
> span 2
> 
> What I wanted to do was 
> 
> isdn30B->(1)te410p(2)->merdian(B)
> isdn30A->(3)te410p(4)->meridian(a)
> 
> IOW two ISDN30 lines, one going to * span 1, the other to * span 3. * is
> linked to the meridian card A by span 2 and card B by span 4.
> 
> However: * reported everything was fine except span 4 - the D channel
> kept going up and down, and I got a Clock Controller error and red alarm
> on the merdian.

Does zttool on the Asterisk box show anything interesting? The files in 
/proz/zaptel/* may provide some insight.

Have you verified that _all_ your spans are set to E1? If the card is 
configured via the jumpers there could be a weak connection.

Finally, are you sure the cable connecting the two is ok and properly 
crossed over? From your schematics above you will need a cross over cable 
when connecting span 4 on asterisk to the meridian.

[snip]

> The channel numbers do not seem right to me - although it works when I
> have my working scenario !!

The channel numbers seem correct to me.

Peter





More information about the asterisk-users mailing list