[Asterisk-Users] (newbie) no dialtone on a TDM400P card

Cirelle Enterprises gcirino at cirelle.com
Sun Nov 14 05:28:56 MST 2004


----- Original Message ----- 
From: "Thomas Andrews" <tandrews at grok.co.za>
To: "Asterisk" <asterisk-users at lists.digium.com>
Sent: Sunday, November 14, 2004 4:19 AM
Subject: [Asterisk-Users] (newbie) no dialtone on a TDM400P card


| I've never set up asterisk before.
| 
| I hear no dialtone on the telephone plugged into the TDM400 card.
| 
| This is what ztcfg -vv gives me:
| 
| Zaptel Configuration
| ======================
| 
| Channel map:
| 
| Channel 01: FXO Loopstart (Default) (Slaves: 01)
| Channel 02: FXS Loopstart (Default) (Slaves: 02)
| 
| 2 channels configured.
| 
Here's the relevant output from dmesg:

Zapata Telephony Interface Registered on major 196
Freshmaker version: 71
Freshmaker passed register test
Module 0: Installed -- AUTO FXS/DPO
Module 1: Installed -- AUTO FXO (FCC mode)
Module 2: Not installed
Module 3: Not installed
Found a Wildcard TDM: Wildcard TDM400P REV E/F (4 modules)
Registered tone zone 0 (United States / North America)
Power alarm on module 1, resetting!
Power alarm on module 1, resetting!


you might have to power the box down - no power for
the modules to load  (appears to be common for this card)
if that is the case, do a search on tdm in the email archive
as there is a fix for the reboot problem

make sure you plugged the phone line into the correct module

module 1 (closest to the top of the bracket (furthest from the pci connector)
is for the phone line
module 2 is for the handset



More information about the asterisk-users mailing list