[Asterisk-Users] (newbie) no dialtone on a TDM400P card

[Rich Adamson]

> > >Power alarm on module 1, resetting!
> > 
> > Have you plugged the power into the TDM400P?
> 
> The wierd thing is that asterisk refuses to start *until* I've had those
> Power alarm error messages. Until then I get these errors:
> 
> => (Zapata Telephony)
>    Parsing '/etc/asterisk/zapata.conf': Found
> Nov 14 12:13:56 WARNING[1490]: chan_zap.c:774 zt_open: Unable to specify channel 1: No 
such device or address
> Nov 14 12:13:56 ERROR[1490]: chan_zap.c:6247 mkintf: Unable to open channel 1: No such 
device or address here = 0, tmp->channel = 1, channel = 1
> Nov 14 12:13:56 ERROR[1490]: chan_zap.c:9202 setup_zap: Unable to register channel '1'
> Nov 14 12:13:56 WARNING[1490]: loader.c:385 ast_load_resource: chan_zap.so: load_module 
failed, returning -1
>   Unregistered channel type 'Zap'
> Nov 14 12:13:56 WARNING[1490]: loader.c:480 load_modules: Loading module chan_zap.so 
failed!

Try these steps if you haven't already:
1. in the /usr/src/zaptel directory, do a 'make config'
2. execute a 'modprobe wctdm'
3. execute a 'ztcfg -vvv'
3. execute 'service zaptel stop' followed by 'service zaptel start'
4. start asterisk

Any difference?