[Asterisk-Users] Newbie x100p install question

Rick Beasley beez at lucent.com
Fri May 7 07:45:13 MST 2004


PROBLEM: My x100p only does bad things. When I plug the line from the 
wall into the card, other phones in my house go nuts, no dialtone, crazy 
clicking, random tones, etc. Following the steps below, the line is 
screwed up any time I test after step 2. Just plugging the line from the 
wall into the x100p takes my other phones off line. External calls to my 
line hear busy. Obviously, can't do the first testing with asterisk+x100p.

1. Installed asterisk
2. Installed card in slot (no shared IRQs)
3. Installed (modprobed) drivers
4. Modified config files to just basics for my environment
5. Ran ztcfg
6. Started asterisk

No errors, asterisk starts fine, modprobe -q shows drivers. Next I'm 
going to experiment with "context" since I've seen several 
recommendations including incoming and bell.

This is kicking my butt, can someone help?

Thanks,
Rick




More information about the asterisk-users mailing list