[Asterisk-Users] Softfax problems

[Jon Creasey]

All,

Using CVS-03/05/04-17:17:29 asterisk
Spandsp 0.0.1f

Getting the following when faxes come in on x100p

Receiver's minimum scan line time: 0ms at 3.85 l/mm: T7.7 = T3.85
R8x15.4lines/mm OK
Minimum scan line time for higher resolutions: T15.4 = T7.7
>>> DIS: 80 00 ce f0 80 80 01
T4 timeout in state 9
Sending ident
>>> CSI: 40 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20
DIS:
Preferred octets: 256
Can receive fax
Supported data signalling rates: V.27ter and V.29
R8x7.7lines/mm and/or 200x200pels/25.4mm OK
2D coding OK
Scan line length: 215mm
Recording length: A4 (297mm)
Receiver's minimum scan line time: 0ms at 3.85 l/mm: T7.7 = T3.85
R8x15.4lines/mm OK
Minimum scan line time for higher resolutions: T15.4 = T7.7
>>> DIS: 80 00 ce f0 80 80 01
HDLC underflow in state 9
Changed from phase 4 to 3
Slow carrier up
Slow carrier down
Slow carrier up
Slow carrier down
Slow carrier up
Slow carrier down
Slow carrier up
Slow carrier down
Slow carrier up
Slow carrier down
T2 timeout
Start receiving document
Changed from phase 3 to 4
Sending ident
>>> CSI: 40 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20
DIS:
Preferred octets: 256
Can receive fax
Supported data signalling rates: V.27ter and V.29
R8x7.7lines/mm and/or 200x200pels/25.4mm OK
2D coding OK
Scan line length: 215mm
Recording length: A4 (297mm)
Receiver's minimum scan line time: 0ms at 3.85 l/mm: T7.7 = T3.85
R8x15.4lines/mm OK
Minimum scan line time for higher resolutions: T15.4 = T7.7
>>> DIS: 80 00 ce f0 80 80 01
T4 timeout in state 9
Sending ident
>>> CSI: 40 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20 20
DIS:
Preferred octets: 256
Can receive fax
Supported data signalling rates: V.27ter and V.29
R8x7.7lines/mm and/or 200x200pels/25.4mm OK
2D coding OK
Scan line length: 215mm
Recording length: A4 (297mm)
Receiver's minimum scan line time: 0ms at 3.85 l/mm: T7.7 = T3.85
R8x15.4lines/mm OK
Minimum scan line time for higher resolutions: T15.4 = T7.7
>>> DIS: 80 00 ce f0 80 80 01
    -- Hungup 'Zap/1-1'


Message from the remote end (TPC.INT)

Your facsimile job to +441142493154 was not sent because:
    DIS/DTC received 3 times; DCS not recognized

The job will be retried at 17:08.

    ---- Transcript of session follows ----

Mar 23 17:03:57.37: [85585]: SESSION BEGIN 00864170 44114xxxxxx
Mar 23 17:03:57.37: [85585]: HylaFAX (tm) Version 4.1.5
Mar 23 17:03:57.37: [85585]: SEND FAX: JOB 10266 DEST +441142xxxxxx COMMID
00864170 DEVICE '/dev/cuac07'
Mar 23 17:03:57.37: [85585]: DELAY 75 ms
Mar 23 17:03:57.45: [85585]: DELAY 2600 ms
Mar 23 17:04:00.06: [85585]: DELAY 10 ms
Mar 23 17:04:00.08: [85585]: <-- [4:ATZ\r]
Mar 23 17:04:00.41: [85585]: --> [3:ATZ]
Mar 23 17:04:00.41: [85585]: --> [2:OK]
Mar 23 17:04:00.41: [85585]: DELAY 3000 ms
Mar 23 17:04:03.42: [85585]: <-- [5:ATE0\r]
Mar 23 17:04:03.48: [85585]: --> [4:ATE0]
Mar 23 17:04:03.48: [85585]: --> [2:OK]
Mar 23 17:04:03.48: [85585]: <-- [5:ATV1\r]
Mar 23 17:04:03.54: [85585]: --> [2:OK]
Mar 23 17:04:03.54: [85585]: <-- [5:ATQ0\r]
Mar 23 17:04:03.60: [85585]: --> [2:OK]
Mar 23 17:04:03.60: [85585]: <-- [7:ATS0=0\r]
Mar 23 17:04:03.66: [85585]: --> [2:OK]
Mar 23 17:04:03.66: [85585]: <-- [7:ATS8=2\r]
Mar 23 17:04:03.72: [85585]: --> [2:OK]
Mar 23 17:04:03.72: [85585]: <-- [8:ATS7=60\r]
Mar 23 17:04:03.78: [85585]: --> [2:OK]
Mar 23 17:04:03.78: [85585]: <-- [6:AT&E4\r]
Mar 23 17:04:03.84: [85585]: --> [2:OK]
Mar 23 17:04:03.84: [85585]: <-- [6:AT&D3\r]
Mar 23 17:04:03.90: [85585]: --> [2:OK]
Mar 23 17:04:03.90: [85585]: <-- [6:AT&C1\r]
Mar 23 17:04:03.96: [85585]: --> [2:OK]
Mar 23 17:04:03.96: [85585]: <-- [12:AT+FCLASS=2\r]
Mar 23 17:04:04.02: [85585]: --> [2:OK]
Mar 23 17:04:04.02: [85585]: <-- [10:AT+FTBC=0\r]
Mar 23 17:04:04.08: [85585]: --> [2:OK]
Mar 23 17:04:04.08: [85585]: <-- [10:AT+FBOR=0\r]
Mar 23 17:04:04.14: [85585]: --> [2:OK]
Mar 23 17:04:04.14: [85585]: <-- [13:AT+FPHCTO=30\r]
Mar 23 17:04:04.20: [85585]: --> [2:OK]
Mar 23 17:04:04.20: [85585]: <-- [24:AT+FDCC=1,5,2,2,2,0,0,0\r]
Mar 23 17:04:04.27: [85585]: --> [2:OK]
Mar 23 17:04:04.27: [85585]: <-- [5:ATM0\r]
Mar 23 17:04:04.33: [85585]: --> [2:OK]
Mar 23 17:04:04.33: [85585]: <-- [12:AT+FCLASS=2\r]
Mar 23 17:04:04.49: [85585]: --> [2:OK]
Mar 23 17:04:04.49: [85585]: <-- [10:AT+FTBC=0\r]
Mar 23 17:04:04.65: [85585]: --> [2:OK]
Mar 23 17:04:04.65: [85585]: <-- [10:AT+FBOR=0\r]
Mar 23 17:04:04.81: [85585]: --> [2:OK]
Mar 23 17:04:04.81: [85585]: <-- [13:AT+FPHCTO=30\r]
Mar 23 17:04:04.97: [85585]: --> [2:OK]
Mar 23 17:04:04.97: [85585]: <-- [24:AT+FDCC=1,5,2,2,2,0,0,0\r]
Mar 23 17:04:05.14: [85585]: --> [2:OK]
Mar 23 17:04:05.14: [85585]: <-- [25:AT+FLID="Demon Internet"\r]
Mar 23 17:04:05.31: [85585]: --> [2:OK]
Mar 23 17:04:05.32: [85585]: DIAL 01142493154
Mar 23 17:04:05.32: [85585]: <-- [17:ATDT0114xxxxxx@\r]
Mar 23 17:04:23.07: [85585]: --> [5:+FCON]
Mar 23 17:04:25.40: [85585]: --> [28:+FCSI:"                    "]
Mar 23 17:04:25.41: [85585]: REMOTE CSI ""
Mar 23 17:04:25.41: [85585]: --> [21:+FDIS:1,3,0,0,1,0,1,0]
Mar 23 17:04:25.41: [85585]: --> [2:OK]
Mar 23 17:04:25.41: [85585]: REMOTE best rate 9600 bit/s
Mar 23 17:04:25.41: [85585]: REMOTE max page width 1728 pixels in 215 mm
Mar 23 17:04:25.41: [85585]: REMOTE max A4 page length (297 mm)
Mar 23 17:04:25.41: [85585]: REMOTE best vres 7.7 line/mm
Mar 23 17:04:25.41: [85585]: REMOTE best format 2-D MR
Mar 23 17:04:25.41: [85585]: REMOTE best 0 ms/scanline
Mar 23 17:04:25.41: [85585]: USE 9600 bit/s
Mar 23 17:04:25.41: [85585]: USE 0 ms/scanline
Mar 23 17:04:25.41: [85585]: SEND file "docq/doc15408.ps;31"
Mar 23 17:04:25.41: [85585]: USE page width 1728 pixels in 215 mm
Mar 23 17:04:25.41: [85585]: USE A4 page length (297 mm)
Mar 23 17:04:25.41: [85585]: USE 7.7 line/mm
Mar 23 17:04:25.41: [85585]: USE 1-D MR
Mar 23 17:04:25.41: [85585]: <-- [24:AT+FDIS=1,3,0,0,0,0,0,0\r]
Mar 23 17:04:25.57: [85585]: --> [2:OK]
Mar 23 17:04:25.58: [85585]: <-- [7:AT+FDT\r]
Mar 23 17:04:44.76: [85585]: --> [8:+FHNG:26]
Mar 23 17:04:44.76: [85585]: REMOTE HANGUP: DIS/DTC received 3 times; DCS
not recognized (code 26)
Mar 23 17:04:45.04: [85585]: --> [2:OK]
Mar 23 17:07:45.05: [85585]: MODEM <Timeout>
Mar 23 17:07:45.05: [85585]: <-- [5:ATH0\r]
Mar 23 17:07:45.21: [85585]: --> [2:OK]
Mar 23 17:07:45.22: [85585]: SESSION END

Anyone have any ideas.

Jon