[Asterisk-Users] hdlc problems

[Michael Welter]

I'm trying to run both voice and data over a PRI T1 circuit between two 
* boxes (using a crossover cable).  I'm using asterisk and libpri from 
today's cvs.  I can establish voice calls, but I can't pass data.

I have the current version of sethdlc, but none of the protocol options 
(hdlc, hdlc-eth, cisco, ppp) seem to work.  Is there a preferred 
protocol for a direct connect?

I give the home system the following commands:

sethdlc hdlc0 hdlc
ifconfig hdlc0 172.16.2.53 netmask 255.255.0.0
route add -host 172.16.2.54 hdlc0

I give the satellite system the following commands:

ifconfig eth0 down (was 172.16.2.52)
sethdlc hdlc0 hdlc
ifconfig hdlc0 172.16.2.54 netmask 255.255.0.0
route add -host 172.16.2.53 hdlc0
route del default gw 172.16.2.3
route add default gw 172.16.2.53

I tried the 'sethdlc hdlc0 t1' but it wouldn't take.

 From each system, I'm unable to ping the other system.  Is there 
something else I should be doing?

Thanks,

-- 
Michael Welter
Introspect Consulting, Inc.
Denver, Colorado
+1 303 674 2575
mike at introspect.com
www.introspect.com