[Asterisk-Users] Anyone got their Pulver WiSIP phone working with *?

[Steven Sokol]

Are you natted (behind a NAT screen)?

Do you have any other SIP devices connected to the same network segment as
your WiFi Access Point?  Are they working correctly?

I would try turning off the canreinvite (set = 0) and, if there's a NAT
between you and the Asterisk, turn on nat support (nat = yes).

Good luck,

Steve

> -----Original Message-----
> From: asterisk-users-admin at lists.digium.com [mailto:asterisk-users-
> admin at lists.digium.com] On Behalf Of Mark Phillips
> Sent: Tuesday, March 16, 2004 3:04 PM
> To: asterisk-users at lists.digium.com
> Subject: [Asterisk-Users] Anyone got their Pulver WiSIP phone working with
> *?
> 
> Hi Folks,
> 
> Took delivery of 3 of these today and am having problems. Pulver tech
> support is pretty much non existant so I came here.
> 
> Problem is this. Phone configured to talk to * as extn 3405. * shows that
> 3405 has registered and a sip show peers reveals its ip address etc. Make
> a call from the WiSIP to any extension and * shows the call getting as far
> as the native bridge. call fails after that point. If I let the VM pick up
> * plays the VM messages and then hangs up. At no time does the WiSIP think
> its connected.
> 
> In the reverse direction, a call to the WiSIP gets dumped into VM straight
> away.
> 
> If I call the phone by its URI it rings but the calling phone never thinks
> the call has been answered by the WiSIP.
> 
> I have 711 as the codec and inband DTMF (which the WiSIP thinks should be
> 2833).
> 
> Any ideas ...
> 
> Thanks
> 
> 
> --
> Mark Phillips, G7LTT/KC2ENI
> Randolph, NJ
> http://www.g7ltt.com/
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users