[Asterisk-Users] wct1xxp module and the T100P

[Steven Critchfield]

On Wed, 2004-03-03 at 17:16, cveazey at blackhillsfiber.com wrote:
> 
> 
> 
> Steven Critchfield
> <critch at basesys.com>
> Sent by:
> asterisk-users-admin at lists.digium.com
> 
> 03/03/2004 04:06 PM
> Please respond to
> asterisk-users
>         
>         To:      
> asterisk-users at lists.digium.com
>         cc:        
>         Subject:      
> Re: [Asterisk-Users]
> wct1xxp module and the
> T100P
> 
> 
> On Wed, 2004-03-03 at 17:01, cveazey at blackhillsfiber.com wrote:
> > I'm having trouble turning up a PRI to a T100P.  I've read on the
> > Digium FAQ's that once the wct1xxp module is loaded correctly, the
> LED
> > on the T100P will flash red.  I believe I've loaded the module
> > correctly because both wct1xxp and zaptel are listed when I do the
> > "lsmod" command.  The LED on the card does not flash on and off.
> Does
> > anyone have any recommendations on what I could be doing wrong?
> 
> Could be wrong or bad cable, could be incorrect configuration, could
> be
> no service on the line yet.
> 
> Must provide data to get information.
> -- 
> Steven Critchfield  <critch at basesys.com>
> 
> 
> __________________________________________________________________
> 
> I know the PRI is good to the RJ-45 right before it goes into the
> T100P; I've made calls on it with our T-Berd.  So I'm sure the cable
> is ok and there is service on the line.
> 
> I haven't run Asterisk yet; shouldn't the card look "alive" once its
> driver module is loaded?  

Nope, What would answer the request placed on the line. 

BTW, please see about putting some sane configuration options in your
mailer. I know Lotus is notoriously crappy when viewed by other readers,
but that was really bad.

-- 
Steven Critchfield  <critch at basesys.com>