[Asterisk-Users] Robbed Bit T1 Configuration

[mattf]

Hello,
 
We have over a dozen T1s that are all robbed-bit D4/AMI, E&M Wink and we
receive *ANI*DNIS from all of our carriers(10 digit ANI, 4 digit DNIS) and
it all works fine. Who is your carrier? and why can't you get ANI if your
use E&M?
 
MATT---
 

-----Original Message-----
From: Paul Egger [mailto:paul at egger.org]
Sent: Friday, July 23, 2004 5:32 PM
To: 'asterisk-users at lists.digium.com'
<mailto:'asterisk-users at lists.digium.com'> 
Subject: [Asterisk-Users] Robbed Bit T1 Configuration



Is it possible to control the dialing format used when making a call from
asterisk separately from the inbound format?  In my case I have a single
robbed-bit T1 configured for featd (to receive ANI and DNIS) on a TE410P.
This configuration works fine for inbound calls, however when an outbound
call is made on this same T1 asterisk dials outbound in the featd format.  I
need asterisk to only dial the phone number in the dial string (no more, no
less), but as I said before asterisk dials out in the featd format, adding
extra digits.  If I configure the circuit for E&M the outbound calls work
fine, but then I cannot receive the ANI and DNIS on the inbound calls.  I
need to make both inbound and outbound calls on the same T1 is this a
possibility?  Has anyone had this issue or can possibly point me I the right
direction?  Any help would be greatly appreciated.

 

Thanks,

 

Paul

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-users/attachments/20040723/41ccfb60/attachment.htm