[Asterisk-Users] No signal from ISDN-phone connected to hfc card in NT-mode

[Oliver Brandt]

Hello,
I've been playing around for a few more houres and found out the
following:
I figured out you can load the hfc modules with make loadNT-debug. Now I
was getting messages when I picked up the phone or dialed a number. I
still did now see anything in asterisk and the messages don't seem to be
making to much sense (see below).
I just rebooted (no change on the hardware) and now no response to
picking up the phone etc.
I also borrowed a friends phone which does not have it's own power
supply and it is getting power just fine from the NTBA.
And I crimted (probably only German word: a way to put plugs on an
ISDN cable) an ISDN-cross cable without resistors and without the NTBA.
I checkt the wiering of the new cable as well as the old one with the
NTBA with a multimeter.
Nothing helped.
I'm totally lost!


Best regards!
	Oliver

Messages from /var/log/kernel.log:

After rebooting:
After running make loadNT-debug:
  Aug 26 23:44:58 stoibi kernel: PCI: Enabling device 0000:00:0e.0 (0000
  -> 0003)
  Aug 26 23:44:58 stoibi kernel: ACPI: PCI interrupt 0000:00:0e.0[A] ->
  GSI 11 (level, low) -> IRQ 11
  Aug 26 23:44:58 stoibi kernel: zaphfc: CCD/Billion/Asuscom 2BD0
  configured at mem 0xe08c4000 fifo 0xd39f8000(0x139f8000)
  IRQ 11 HZ 1000
  Aug 26 23:44:58 stoibi kernel: zaphfc: Card 0 configured for NT mode
  Aug 26 23:44:58 stoibi kernel: zaphfc: 1 hfc-pci card(s) in this box.
  Aug 26 23:44:58 stoibi kernel: Registered tone zone 3 (Netherlands)
  Aug 26 23:44:58 stoibi kernel: zaphfc: card 0 layer 1 state = G2

Nothing more untill I start asterisk:
  Aug 27 00:00:27 stoibi kernel: zaphfc: card 0 TX 8 bytes [ 0xfe 0xff
  0x3 0xf 0x14 0x3f 0x6 0xff !]
  Aug 27 00:00:27 stoibi kernel: zaphfc: card 0 TX 8 bytes [ 0xfe 0xff
  0x3 0xf 0x8a 0x51 0x6 0x81 !]
  Aug 27 00:00:27 stoibi kernel: zaphfc: card 0 TX 8 bytes [ 0xfe 0xff
  0x3 0xf 0x37 0xf5 0x6 0x83 !]
  Aug 27 00:00:27 stoibi kernel: zaphfc: card 0 TX 8 bytes [ 0xfe 0xff
  0x3 0xf 0x88 0x5d 0x6 0x85 !]
  Aug 27 00:00:27 stoibi kernel: zaphfc: card 0 TX 8 bytes [ 0xfe 0xff
  0x3 0xf 0xa8 0xe7 0x6 0x87 !]
  Aug 27 00:00:27 stoibi kernel: zaphfc: card 0 TX 8 bytes [ 0xfe 0xff
  0x3 0xf 0x13 0xee 0x6 0x89 !]
  Aug 27 00:00:27 stoibi kernel: zaphfc: card 0 TX 8 bytes [ 0xfe 0xff
  0x3 0xf 0xba 0x9e 0x6 0x8b !]
  Aug 27 00:00:27 stoibi kernel: zaphfc: card 0 TX 8 bytes [ 0xfe 0xff
  0x3 0xf 0x90 0x96 0x6 0x8d !]
  Aug 27 00:00:27 stoibi kernel: zaphfc: card 0 TX 8 bytes [ 0xfe 0xff
  0x3 0xf 0xde 0x2b 0x6 0x8f !]
  Aug 27 00:00:27 stoibi kernel: zaphfc: card 0 TX 8 bytes [ 0xfe 0xff
  0x3 0xf 0xd9 0x6b 0x6 0x91 !]
  Aug 27 00:00:27 stoibi kernel: zaphfc: card 0 TX 8 bytes [ 0xfe 0xff
  0x3 0xf 0x61 0x31 0x6 0x93 !]
  Aug 27 00:00:27 stoibi kernel: zaphfc: card 0 TX 8 bytes [ 0xfe 0xff
  0x3 0xf 0xaf 0xd 0x6 0x95 !]
  Aug 27 00:00:27 stoibi kernel: zaphfc: card 0 TX 8 bytes [ 0xfe 0xff
  0x3 0xf 0xa8 0x50 0x6 0x97 !]
  Aug 27 00:00:27 stoibi kernel: zaphfc: card 0 TX 8 bytes [ 0xfe 0xff
  0x3 0xf 0xe 0x4f 0x6 0x99 !]
  Aug 27 00:00:27 stoibi kernel: zaphfc: card 0 TX 8 bytes [ 0xfe 0xff
  0x3 0xf 0xe0 0x88 0x6 0x9b !]
  Aug 27 00:00:27 stoibi kernel: zaphfc: card 0 TX 8 bytes [ 0xfe 0xff
  0x3 0xf 0x56 0xe6 0x6 0x9d !]
  Aug 27 00:00:27 stoibi kernel: zaphfc: card 0 TX 8 bytes [ 0xfe 0xff
  0x3 0xf 0xc 0xc0 0x6 0x9f !]
 
Nothing else seams to happen. No response to picking up the phone or
dialing. Bevor I rebooted messages like the above were showing up, when
dialing etc.