[Asterisk-Users] How to run different codecs between the same endpoints on an IAX trunk?

[steve at daviesfam.org]

On Thu, 19 Aug 2004, Kris Boutilier wrote:

> Or perhaps how to configure and refer to two parallel IAX trunks with
> different codecs?
> 
> I have a situation where I'm using G.729A as my IAX trunking codec. Now I
> need to push some short duration, low bitrate modem traffic over the link (a
> credit card terminal). Obviously the modem audio isn't going to survive the
> G.729 codec process intact, so for the times the device is used I'd like to
> service calls from that device (and only that device) with a higher-data
> rate codec.


How about two IP addresses at the remote end, configure two peers, one 
with trunking anf G729, one without and G711?

Steve