[Asterisk-Users] Cisco 2600 and ASTERISK

[Joseph Finley]

That's exactly what I encountered every time....I eventually gave up on
it...Brian (bkw) gave me the configs and all, but was unable to get it to
work....

-----Original Message-----
From: asterisk-users-admin at lists.digium.com
[mailto:asterisk-users-admin at lists.digium.com] On Behalf Of Bartosz Jozwiak
Sent: Friday, September 26, 2003 11:24 AM
To: asterisk-users at lists.digium.com
Subject: Re: [Asterisk-Users] Cisco 2600 and ASTERISK


I just get all time fast bussy signal.


----- Original Message ----- 
From: "Sean Figgins" <sfiggins at mail.celicas.org>
To: <asterisk-users at lists.digium.com>
Sent: Friday, September 26, 2003 11:58 AM
Subject: Re: [Asterisk-Users] Cisco 2600 and ASTERISK


> On Fri, 26 Sep 2003, Bartosz Jozwiak wrote:
> 
> > I have pointed it to Asterisk for sure not to local cisco ethernet. 
> > I think there is something wrong with the router.
> 
> In the exerpt from the config you posted (below), the destination in 
> the dial-peer is the same as the address on the enternet interface.  
> Perhaps this is not your actual config?
> 
> In any event, if this is correct, it should work.
> 
> > > > dial-peer voice 1000 voip
> > > >  max-conn 4
> > > >  destination-pattern 9999
> > > >  req-qos guaranteed-delay
> > > >  codec g711ulaw
> > > >  ip precedence 5
> > > >  no vad
> > > >  session target ipv4:66.178.37.169
> > > > !
> > > > !
> > > > interface Ethernet0/0
> > > >  ip address 66.178.37.169 255.255.254.0
> > > >  no ip directed-broadcast
> > > >  half-duplex
> 
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com 
> http://lists.digium.com/mailman/listinfo/asterisk-users
> 

_______________________________________________
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users