[Asterisk-Users] configuring TE410P for four E1 PRI lines

[Richard Smith]

Rahul Arvind Jadhav wrote:

> hi,
>    I'm trying to configure my newly acquired TE410P card to work as 4 E1 
> spans. This is
> supposed to be a drop-in replacement to the earlier E100P card. However, 
> on loading the
> zaptel module it gets configured as T1 spans basically doing a 'cat' on 
> /proc/zaptel/1 thru 4,
> it shows 24 channels per span. After this ztcfg fails saying 
> 'ZT_CHANCONFIG failed for channel 97'.
> This is obviously because Quad T1 has only 96 channels. The question is 
> how do i get the zaptel module
> to recognize the card as Quad E1 and not Quad T1.
> My current /etc/zaptel.conf goes as follows:
> 

There's jumpers on the board that are clearly marked.

Jumper on = E1
Jumper Off = T1

Hope this helps..

--
Richard