[Asterisk-Users] e100p and E-bit alarm indication

[Lele Forzani]

We connected an * box with an e100p to an E1/PRI from a telco here in Italy.

After we had it working perfectly the telco told us that, despite the circuit 
appeared to work fine, and we could place calls on it, they had an "E-bit2 
alarm indication constantly on that caused the circuit to be flagged as 
"faulty" every time.

(The E-bit indication, is an alarm sent back from us to the telco, telling 
them we are getting CRC-errored data from them. It should be incrementing the 
"Far-End SES" on their side)

Since the circuit appeared to work fine, calls went through, and the crc 
counters on our side was zero, it was impossible we were getting that many 
errors and something must have been wrong with our handling of the E-bit 
signal.

I've come across the DS21554 framer documentation and i've seen that it has a 
flag for enabling the E-bit generation in the "TCR2" register and that the 
wct1xxp.c wasn't setting it. 

So i tried this small patch and the telco is perfectly happy with it, now, the 
E-bit error has disappeared.


Since there had been a thread in May (started by Konrad Gorsky) about weird 
far end CRC errors i'm posting in the hope to help somebody.

Note that i do not have a clue on what this does to the *T1* framer. I do not 
have the specs for it!

bye
lele





--- zaptel/wct1xxp.c    2003-09-12 10:12:01.000000000 +0200
+++ zaptel-i/wct1xxp.c  2003-09-11 19:24:53.000000000 +0200
@@ -411,13 +411,14 @@
        int alreadyrunning = wc->span.flags & ZT_FLAG_RUNNING;
        long flags;
        char *crcing = "";
-       unsigned char ccr1, tcr1;
+       unsigned char ccr1, tcr1, tcr2;

        spin_lock_irqsave(&wc->lock, flags);

        /* Build up config */
        ccr1 = 0;
        tcr1 = 8;
+       tcr2 = 0;
        if (wc->span.lineconfig & ZT_CONFIG_CCS) {
                coding = "CCS"; /* Receive CCS */
                ccr1 |= 8;
@@ -433,9 +434,11 @@
        }
        if (wc->span.lineconfig & ZT_CONFIG_CRC4) {
                ccr1 |= 0x11;
+               tcr2 |= 0x02;   // xxx Enable E-bit alarm
                crcing = " with CRC4";
        }
        __t1_set_reg(wc, 0x12, tcr1);
+       __t1_set_reg(wc, 0x13, tcr2);
        __t1_set_reg(wc, 0x14, ccr1);
        __t1_set_reg(wc, 0x18, 0x20);   /* 120 Ohm */