[Asterisk-Users] TDM400P Problem

[Steve Totaro]

I had the same thing and just figured it out yesterday!

the problem is that the tdm400p is failing calibration.  type "dmesg" and it will tell you.  

uncomment in zaptel/Makefile KFLAGS+=-DNO_CALIBRATION in the source code and "make clean install"

It worked for me but I wonder if there is a bad batch of cards?  I was in the "backordered till Sept 2nd batch"  I am assuming its not good to fail calibration?

Steve Totaro


  ----- Original Message ----- 
  From: How Peng Kaiam 
  To: asterisk-users at lists.digium.com 
  Sent: Thursday, September 11, 2003 9:52 AM
  Subject: [Asterisk-Users] TDM400P Problem


  Hi,

  Just received the TDM400P and X100P.
  PC can detect the X100P, but not the TDM400P.
  Tried to load the wcfxs module, reported:
  modprobe wcfxs
  > /lib/modules/2.4.20-20.9/misc/wcfxs.o: init_module: No such device
  > Hint: insmod errors can be caused by incorrect module parameters,
  including
  > invalid IO or IRQ parameters.
  >       You may find more information in syslog or the output from dmesg
  > /lib/modules/2.4.20-20.9/misc/wcfxs.o: insmod
  > /lib/modules/2.4.20-20.9/misc/wcfxs.o failed
  > /lib/modules/2.4.20-20.9/misc/wcfxs.o: insmod wcfxs failed
  Any advise.
  Thanks.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-users/attachments/20030911/de66db2f/attachment.htm