[Asterisk-Users] TE410P startup

[Michael Bielicki]

we have now perfect results with yesterdays cvs and the te410p
todays cvs allways thinks that immediate is set to yes in zapata.conf. weird 
...

cheers
Michael

On Sunday 27 July 2003 7:12 pm, Mark Spencer wrote:
> > I put a TE410P card in a machine (a Tyan 2665 with 2x2.4GHz Xeons). A
> > red flashing light circles around the 4 RJ48C sockets. I load the
> > wct4xxp driver, and the flashing light stops. Whether I connect an E1
> > signal or not, no lights are shown, and no alarms are reports in the
> > /proc/zaptel/XXX files.  What is supposed to happen? I expected all the
> > ports to show a continuous red LED until I plugged in an E1, and then to
> > go green. That is what the other Digium cards do.
>
> First, if you want to run in E1 mode you either need to put jumpers on the
> T1/E1 select jumpers located just south-west of the middle of the board
> (and labeled).  Place a jumper on each span you want to be E1.
>
> Then you'll need to edit your /etc/zaptel.conf and make sure you have E1
> spans defined.
>
> Finally, if the lights don't go red, then you might need to manually run
> ztcfg.
>
> If all else fails, be *sure* you're running latest CVS :)
>
> Mark
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users