[Asterisk-Users] reload not working

[Marcus Adolfsson]

I have three Cisco 7960 phones/SIP 5.3 using two Wildcard X100Ps and IAX
service from Nufone. It worked fine on my earlier installed CVS from
6/10. I have not noticed any random hangs, altough it has only been
running for two days.

Thanks,

Marcus

-----Original Message-----
From: asterisk-users-admin at lists.digium.com
[mailto:asterisk-users-admin at lists.digium.com] On Behalf Of Todd
Lieberman
Sent: Wednesday, August 20, 2003 11:21 AM
To: asterisk-users at lists.digium.com
Subject: RE: [Asterisk-Users] reload not working


Martin - et all,

I'm having the same issue.  I have a PRI T1 on a T100P with six 7940
Cisco Phones w/SIP load 4.4. What hardware do u have?  The worst part is
that my system will sometimes just busy out even if I do not issue a
reload command! However if I issue reload it's a sure thing * will hang.

I spoke w/Martin at digium about this last week but we never resolved it
and my system has been hung 3 times in two weeks.  Each time it hangs I
killall -9 asterisk, cvs update & restart.  He said he was working on
the releasing of a PRI channel code last week and that the Telco and *
may not be jiving
correctly.   I had the problem w/the 7/8/2003 cvs so the issue probably
still exists.

I'll report any findings from asterisk -vvvvvvvvvvvvgc as soon as I find
any on my side, I just don't want to take down * during business hours.
So tonight I'll restart w/asterisk -vvvvvvvvvvvvgc try and get to the
bottom of this w/you.  TL

Here is what he Martin at digium recommended:


> Well if you use sip phones you might want to have "sip debug" turned 
> on. But if you have many SIP phones then you're going to have lots of 
> SIP messages.

> The "zap show channels" output is broken. It might show some false 
> messages. Instead do "zap show channel <chann_no>" If the PRI Flag is 
> "Call" then this channel hasn't been cleared properly. If it's empty 
> than it's ok. If the channel is not serviced by your telco it's going 
> to be in "Restarting" state.
>
> Also make sure then when you restart asterisk that all the 23 channels

> get restarted at the very begining.
>
> regards
> Martin




-----Original Message-----
From: asterisk-users-admin at lists.digium.com
[mailto:asterisk-users-admin at lists.digium.com]On Behalf Of Marcus
Adolfsson
Sent: Wednesday, August 20, 2003 9:05 AM
To: asterisk-users at lists.digium.com
Subject: [Asterisk-Users] reload not working


I upgraded to the latest CVS yesterday (and this morning again), and
whenever I execute the reload command Asterisk seems to hang. While the
current calls aren't dropped, no new calls can be made. The CLI isn't
responding properly either. The only way to get going again is to exit
the CLI and stop Asterisk and start again. Any comments?

Thanks,

Marcus

_______________________________________________
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users

_______________________________________________
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users