[Asterisk-Users] reload not working

[Todd Lieberman]

Martin - et all,

I'm having the same issue.  I have a PRI T1 on a T100P with six 7940 Cisco
Phones w/SIP load 4.4. What hardware do u have?  The worst part is that my
system will sometimes just busy out even if I do not issue a reload command!
However if I issue reload it's a sure thing * will hang.

I spoke w/Martin at digium about this last week but we never resolved it and my
system has been hung 3 times in two weeks.  Each time it hangs I killall -9
asterisk, cvs update & restart.  He said he was working on the releasing of
a PRI channel code last week and that the Telco and * may not be jiving
correctly.   I had the problem w/the 7/8/2003 cvs so the issue probably
still exists.

I'll report any findings from asterisk -vvvvvvvvvvvvgc as soon as I find any
on my side, I just don't want to take
down * during business hours.  So tonight I'll restart
w/asterisk -vvvvvvvvvvvvgc try and get to the bottom of this w/you.  TL

Here is what he Martin at digium recommended:


> Well if you use sip phones you might want to have "sip debug" turned on.
> But if you have many SIP phones then you're going to have lots of SIP
> messages.

> The "zap show channels" output is broken. It might show some false
> messages. Instead do "zap show channel <chann_no>" If the PRI Flag is
> "Call" then this channel hasn't been cleared properly. If it's empty than
> it's ok. If the channel is not serviced by your telco it's going to be in
> "Restarting" state.
>
> Also make sure then when you restart asterisk that all the 23 channels get
> restarted at the very begining.
>
> regards
> Martin




-----Original Message-----
From: asterisk-users-admin at lists.digium.com
[mailto:asterisk-users-admin at lists.digium.com]On Behalf Of Marcus
Adolfsson
Sent: Wednesday, August 20, 2003 9:05 AM
To: asterisk-users at lists.digium.com
Subject: [Asterisk-Users] reload not working


I upgraded to the latest CVS yesterday (and this morning again), and
whenever I execute the reload command Asterisk seems to hang. While the
current calls aren't dropped, no new calls can be made. The CLI isn't
responding properly either. The only way to get going again is to exit
the CLI and stop Asterisk and start again. Any comments?

Thanks,

Marcus

_______________________________________________
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users