[Asterisk-Users] PRI Setup

[Steven Critchfield]

You mention this is on your cisco, is it a data line, or a voice line?

On Wed, 2003-04-30 at 17:20, Michael Baird wrote:
> Heh guys, I just received a T400 card, I've been using a T100 for a
> little while, and it works fine when using a raw channelized T1. I'm
> relocating my asterisk machine, and PRI's will only be available,
> haven't found any good config info for PRI's, can someone point me to
> PRI config info, or let me know what changes I need to make in order to
> bring them up, I imagine, zapata.conf and zaptel.conf will require some
> changes to bring the PRI up. The PRI is currently hooked up to my cisco
> 
> controller T1 1/0
>  framing esf
>  linecode b8zs
>  cablelength short 110
>  pri-group timeslots 1-24
> 
> interface Serial1/0:23
>  no ip address
>  no logging event link-status
>  isdn switch-type primary-5ess
>  isdn incoming-voice voice
>  no cdp enable
> 
> Regards
> MIKE
> 
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
-- 
Steven Critchfield  <critch at basesys.com>