[Asterisk-Users] PRI Setup

[Michael Baird]

Heh guys, I just received a T400 card, I've been using a T100 for a
little while, and it works fine when using a raw channelized T1. I'm
relocating my asterisk machine, and PRI's will only be available,
haven't found any good config info for PRI's, can someone point me to
PRI config info, or let me know what changes I need to make in order to
bring them up, I imagine, zapata.conf and zaptel.conf will require some
changes to bring the PRI up. The PRI is currently hooked up to my cisco

controller T1 1/0
 framing esf
 linecode b8zs
 cablelength short 110
 pri-group timeslots 1-24

interface Serial1/0:23
 no ip address
 no logging event link-status
 isdn switch-type primary-5ess
 isdn incoming-voice voice
 no cdp enable

Regards
MIKE