[asterisk-ss7] chan_ss7 - initial alignment failed

[equis software]

Wayne Lau found my error,
in zaptel.conf  I made this change...
#dchan=16
bchan=16

Thanks!

On Fri, Feb 5, 2010 at 9:21 AM, equis software <equissoftware at gmail.com>wrote:

> I´m using Digium TE100P (1 E1), I was using this card with PRI signaling
> without problems. In fact zaptel.conf didn´t change.
>
> I think the cable is ok, because when I connect with my provider (UTStarcom
> switch) the card led turn to green.
> I will test with a loop.
>
> Thanks
>
>
> On Fri, Feb 5, 2010 at 6:36 AM, Goke M Aruna <goksie at gmail.com> wrote:
>
>> I will advise you put a physical loop-back cable on the port and confirm
>> your configuration is okay  and later work with your provider.
>>
>>
>>
>>
>> On Thu, Feb 4, 2010 at 10:13 PM, Peter Petrov <peterpet at mail.ru> wrote:
>>
>>> hi, check the physical transport layer. Check the cable, and if you have
>>> optical E1 modems check the right configuration of the jumpers! In the past
>>> i have the same message and i fix this with right configured jumpers on
>>> modems on my side and Telco side. and what kind of E1 card you are use for
>>> this SS7?
>>>
>>> --
>>> _____________________________________________________________________
>>> -- Bandwidth and Colocation Provided by http://www.api-digital.com --
>>>
>>> asterisk-ss7 mailing list
>>> To UNSUBSCRIBE or update options visit:
>>>    http://lists.digium.com/mailman/listinfo/asterisk-ss7
>>>
>>
>>
>> --
>> _____________________________________________________________________
>> -- Bandwidth and Colocation Provided by http://www.api-digital.com --
>>
>> asterisk-ss7 mailing list
>> To UNSUBSCRIBE or update options visit:
>>   http://lists.digium.com/mailman/listinfo/asterisk-ss7
>>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-ss7/attachments/20100205/51ffe8e0/attachment-0001.htm