[asterisk-ss7] chan_ss7 - initial alignment failed

[equis software]

I´m using Digium TE100P (1 E1), I was using this card with PRI signaling
without problems. In fact zaptel.conf didn´t change.

I think the cable is ok, because when I connect with my provider (UTStarcom
switch) the card led turn to green.
I will test with a loop.

Thanks

On Fri, Feb 5, 2010 at 6:36 AM, Goke M Aruna <goksie at gmail.com> wrote:

> I will advise you put a physical loop-back cable on the port and confirm
> your configuration is okay  and later work with your provider.
>
>
>
>
> On Thu, Feb 4, 2010 at 10:13 PM, Peter Petrov <peterpet at mail.ru> wrote:
>
>> hi, check the physical transport layer. Check the cable, and if you have
>> optical E1 modems check the right configuration of the jumpers! In the past
>> i have the same message and i fix this with right configured jumpers on
>> modems on my side and Telco side. and what kind of E1 card you are use for
>> this SS7?
>>
>> --
>> _____________________________________________________________________
>> -- Bandwidth and Colocation Provided by http://www.api-digital.com --
>>
>> asterisk-ss7 mailing list
>> To UNSUBSCRIBE or update options visit:
>>    http://lists.digium.com/mailman/listinfo/asterisk-ss7
>>
>
>
> --
> _____________________________________________________________________
> -- Bandwidth and Colocation Provided by http://www.api-digital.com --
>
> asterisk-ss7 mailing list
> To UNSUBSCRIBE or update options visit:
>   http://lists.digium.com/mailman/listinfo/asterisk-ss7
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-ss7/attachments/20100205/01da35b7/attachment.htm