[asterisk-ss7] Libss7 configuration

[Andreas Kaufmann]

Hi all,

I have a problem with my libss7 configuration, using a Digium TE220 with
2xE1. There is only one signal channel on channel 1 of the first E1.

Everything works fine for the first 30 channels on the first E1, but
when using the second E1 the call is connected but there is no voice.

Any ideas?

Setup:

- asterisk-1.6.0.1
- dahdi-linux-2.0.0
- libss7-1.0.2
- Digium TE220P 2xE1


/etc/dahdi/system.conf:
-----------------------
span=1,1,0,ccs,hdb3,crc4
span=2,2,0,ccs,hdb3,crc4
mtp2=1
bchan=2-31
bchan=32-62

loadzone=us
defaultzone=us
------------------------


chan_dahdi.conf:
------------------------
[trunkgroups]

[channels]

context = ss7-incoming  ; dialplan context for incoming calls
signalling = ss7        ; signalling type
ss7type = itu           ; itu or ansi if you are using an ANSI link
linkset = 1             ; pick a number for your linkset identifier
pointcode = xxxx        ; The decimal form of your point code.
adjpointcode = yyyy     ; The point code of the switch adjacent to your 
linkset
defaultdpc = yyyy       ; The point code of the switch you want to send 
your ISUP
                         ; traffic to.
; SS7 group definition
group = 1               ; for use in dial(dahdi/g1/...)
networkindicator = national_spare
; channel definition
sigchan = 1
cicbeginswith = 2
channel = 2-31
cicbeginswith = 32
channel = 32-62
---------------------------

Regards,
Andreas